标题:plastic standard hopper dryer
作者:
日期:2020-05-07 08:27:23
内容:
1. Before we use the machine, we need to conduct a dry run test, and before the test, we must also check the firmness of all the connectors of the plastic drying and color mixing machine. We also need to check the amount of lubricant in the high-speed machine and the electrical equipment. Integrity, then close the main switch in the machine, and finally turn on the power supply to carry out the dry-running test machine.
2. The test of idling. Only when the abnormal noise and some undesirable phenomena are not found, can the plastic drying and color mixing machine be used and put into production.
3. If the bucket wall material in the shoveling machine is needed during operation, I need to use the tools of bamboo and woodware, and I must not use my hand, in order to avoid accidents caused by hand injury.
4. If abnormal vibration or abnormal noise is found during use, it should be stopped immediately for comprehensive inspection.
5. Do not use too much load on the machine. Under normal circumstances, we can use the load of the motor to measure, for example: the heavy load current when using a 380 volt motor to mix plastic, we do not exceed 6 amperes as the standard If it exceeds this standard, the mixing amount should be reduced immediately.
6. The shaft seals at both ends of the mixing paddle need to maintain a clean degree, so as to avoid the problems of blackening and deterioration of our plastics. The machine also needs to be smooth, and must not be blocked by the plastic drying and color mixing machine, so that it can avoid adverse reactions. The action of pressure will allow dirt to penetrate into the axis and make the material in the barrel black and deteriorate.
7. The management personnel must be familiar with the technical performance, internal structure, control structure and use principle of the plastic dryer. Do not leave the work place during operation to prevent malfunctions and damage to the machine parts.
Dongguan Hengju Machinery Equipment Co., Ltd. is a manufacturer specializing in the production of plastic peripheral auxiliary equipment; we can provide customers with plastic molding workshops to provide whole-plant design solutions; from the workshop rough grain → raw material storage → raw material ratio measurement → crushing and recycling → Dehumidification and drying → Transport to the application and management of the modern workshop of the molding machine.
The centralized feeding system includes the automatic feeding system for water, electricity, and gas of the whole plant; stand-alone equipment: slow-speed pulverizer, medium-speed pulverizer, machine-side pulverizer, dehumidification dryer, three-in-one dehumidifier, plastic auxiliary machine, Plastic dryer, crystallizer, suction machine, stainless steel dryer, mixer, sieve machine, mold temperature machine, chiller, weighing mixer, volumetric meter.